How 3 out of 10 works out to 30%
Divide the score by the total and multiply by a hundred: 3 ÷ 10 × 100 = 30%. Each of the 10 questions is worth 10%, so the grade can only land on multiples of 10% — there is no way to score 35% on a ten-question test.
7 questions were wrong out of 10, and together they cost 70%. If any of them were marked with partial credit the real figure is a little higher — the test grade calculator takes half marks.
30% as a letter grade
Schools do not all cut letters at the same percentage, so 30% has more than one correct answer. Here is where it lands on the three scales in common US use:
| Scale | Where 30% lands | Grade points |
|---|---|---|
| Plus/minus, the most common US scale | F | 0.00 |
| Straight letters, 90/80/70/60 | F | 0.00 |
| Seven-point, 93/85/77/70 | F | 0.00 |
On the plus/minus scale this site uses throughout, 3 out of 10 is an F, worth 0.00 grade points on an unweighted 4.0 scale. A school that grades in straight letters would record it as an F too. A seven-point scale reads it as an F as well. The full band table for all three, and what each letter is worth on the 4.0, 4.3 and 5.0 scales, is on letter grade to GPA.
What it takes to reach a D-
The next letter up is a D-, which starts at 60%. On a ten-question test that is 6 out of 10 — 3 more correct answers than you have.
What 3 out of 10 needs to pass
A ten-question test allows 4 wrong answers before a 60% pass mark is missed. This paper has 7 wrong — 3 too many — which puts the shortfall at 30% of the grade, or 3 more correct answers (6 out of 10). That is a gap of substance rather than a marking argument.
A single failing test is not usually a failing course. If this paper is worth 20% of the grade and everything else is at 85%, the course still sits at 74% — the table further down shows the other weightings. The number that decides the outcome is the course grade, not this one, and the final grade calculator will tell you what the remaining work has to be.
The scores either side of 3 out of 10
One more correct answer is 4 out of 10, 40% — still an F. One fewer is 2 out of 10, 20% — still an F. Nothing exists in between. A ten-question test has exactly 10 achievable grades above zero and 30% is one of them; a percentage that is not a multiple of 10% cannot come off a test this length, whatever a rounding rule does to it afterwards.
What 30% does to a course average
One test is rarely the whole grade. If everything else in the course is averaging 85% and this test is worth the share in the left-hand column, the course grade lands here:
| Test is worth | Course grade | Letter |
|---|---|---|
| 10% of the course | 79.5% | C+ |
| 20% of the course | 74% | C |
| 30% of the course | 68.5% | D+ |
| 40% of the course | 63% | D |
Because 30% is below that 85% baseline, this test pulls the course average down by 11 points at a 20% weighting. Weightings vary, and a syllabus that puts the final at 30% is a different problem from one that puts it at 10% — put your own categories into the grade calculator, or work backwards from the grade you need with the final grade calculator.
30% on other test lengths
30% is not unique to a ten-question test. The same percentage comes out of 6 out of 20, 9 out of 30, 12 out of 40, 15 out of 50, 18 out of 60 and 30 out of 100. The letter grade is identical on all of them, because the letter only ever looks at the percentage. What differs is the granularity: 3 out of 10 moves in steps of 10%, while 30 out of 100 moves in steps of 1%, so the longer test can express grades the shorter one simply cannot reach.
About ten-question tests
A ten-item test or a ten-point rubric. Every item carries a full ten percentage points, so the grade jumps a whole letter or more at a time and there is no such thing as a borderline score. Every score on one, from 1 to 10, is charted on the out of 10 page, and the easy grader turns the same table around for marking a stack of papers: count what is wrong rather than what is right.